In this lesson, we introduce the simple steps to measure, calibrate and program your inductive position sensor for maximum accuracy. We show how to use the simple and powerful IPCE auto-calibration feature along with a LXM9518 programmer to optimize the calibration points in the sensor according to the measured data. It is a great example of how Microchip simplifies your sensor design. In the video we use the LXE3302AL002 sensor EVB, but the procedure can be applied to any of our EVBs. Below are links to the IPCE software, LXM9518 programmer, LX3302A and LX3301A product pages and evaluation boards. 1. You can download the IPCE software from our Getting Started with Inductive Sensors design page. https://www.microchip.com/en-us/products/sensors-and-motor-drive/inductive-position-sensors/getting-started-with-inductive-position-sensors 2. LXM9518 Programmer product page for use with the IPCE software. https://www.microchip.com/Developmenttools/ProductDetails/LXM9518 3. LX3302A product Page: Inductive Position Sensor IC with a max 150 degC operating temperature and analog, PWM, SENT and PSI5 outputs https://www.microchip.com/wwwproducts/en/LX3302A 4. LX3301A Product Page: Inductive Position Sensor IC with a Max 125 degC operating temperature and Analog and PWM outputs. https://www.microchip.com/wwwproducts/en/LX3301A 5. Inductive Position Sensor Overview Page. https://www.microchip.com/en-us/products/sensors-and-motor-drive/inductive-position-sensors 6. LX3302AL002 100mm Linear Evaluation Board. https://www.microchip.com/Developmenttools/ProductDetails/LXE3302AL002