SAM V71 XPLAINED ULTRA EVALUATION KIT

• ATSAMV71Q21 microcontroller
• ARM® Cortex®-M7 based microcontrollers
• One mechanical reset button
• One power switch button
• Two mechanical user pushbuttons
• Two yellow user LEDs
• Supercap backup
• 12.0 MHz crystal
• 32.768 kHz crystal
• 2 MB QSPI Flash
• IEEE 802.3az 10Base-T/100Base-TX with KSZ8061 Ethernet PHY via RMII
• AT24MAC402 256KByte EEPROM with EUI-48 address
• Stereo audio codec - External PLL for precise clock generation. Microphone jack. Headphone jack.
• ATA6561 CAN Transceiver
• Camera interface connector
• MediaLB connector
• Two Xplained Pro extension headers
• One Xplained Pro LCD header
• Coresight 20 connector for 4-bit ETM
• Arduino due compatible shield connectors
• External debugger connector
• USB interface, device and host mode
• Embedded Debugger
  • Auto-ID for board identification in Atmel Studio
  • One yellow status LED
  • One green board power LED
  • Symbolic debug of complex data types including scope information
  • Programming and debugging
  • Data Gateway Interface: SPI, I2C, 4 GPIOs
  • Virtual COM port (CDC)
• External power input (5-14V)
• USB powered
• J600 (SD Socket Connector) and U801 (Programmable PLL) is Not Populated
• U604 (SPI Flash) Manufacturer Part Number (MPN) changed to Auto Qualified MPN for Rev. 16 only

NOTE: The SDRAM usage on the SAM E70/S70/V70/V71 MCUs is not suggested in new designs as the SDRAM controller is not functional. The SDRAM support has been removed from all versions of SAM E70/S70/V70/V71 devices. Microchip does not guarantee the functionality of the SDRAM controller, and the SDRAM controller might cause issues with the functionality of the parts.