• AVR Freaks

Hot!ATSAMA5D27 Pin mUX tool

Author
roshandsouza6
New Member
  • Total Posts : 2
  • Reward points : 0
  • Joined: 2021/02/14 02:59:09
  • Location: 0
  • Status: offline
2021/02/17 04:21:30 (permalink)
0

ATSAMA5D27 Pin mUX tool

Hello, Ia m planning to design a board using ATSAMA5D27 or sip chip. To assign the pin outs I need io mux/pin mux tool to start the design. Is there any tool for this and where to download the same?
#1

3 Replies Related Threads

    blue_z
    Starting Member
    • Total Posts : 13
    • Reward points : 0
    • Status: offline
    Re: ATSAMA5D27 Pin mUX tool 2021/02/22 16:12:31 (permalink)
    4 (1)
    Microchip does not seem to offer such a utility for its 32-bit MPU products. 
    Actually, prior to the SAMA5D2, all the SAM9, SAMA5D3 and SAMA5D4 SoCs have peripherals with only one set of pin assignments, so peripheral selection went hand-in-hand with pin assignments. 
    With the SAMA5D2 be sure to assign pins of the same I/O set to each peripheral.
     
    Regards
    post edited by blue_z - 2021/02/22 16:29:14
    #2
    roshandsouza6
    New Member
    • Total Posts : 2
    • Reward points : 0
    • Joined: 2021/02/14 02:59:09
    • Location: 0
    • Status: offline
    Re: ATSAMA5D27 Pin mUX tool 2021/02/22 20:24:42 (permalink)
    0
    Hello, Thanks for your inputs. So we need to manually check and assign the pinouts?
    #3
    blue_z
    Starting Member
    • Total Posts : 13
    • Reward points : 0
    • Status: offline
    Re: ATSAMA5D27 Pin mUX tool 2021/02/23 17:00:26 (permalink)
    4 (1)
    roshandsouza6So we need to manually check and assign the pinouts?
    Guess so. 


    Gee, I remember the days before CAD when everything was "manual" and board schematics were actually drawn on paper.
     
    Regards
    #4
    Jump to:
    © 2021 APG vNext Commercial Version 4.5