• AVR Freaks

Hot!PIC18F STARTER KIT 1 issue

Author
Post
Essentials Only Full Version
memo1402
New Member
  • Total Posts : 2
  • Reward points : 0
  • Joined: 2020/10/27 09:07:36
  • Location: 0
  • Status: offline
2020/10/27 16:14:42 (permalink)
0

PIC18F STARTER KIT 1 issue

Hello,
 
I’m using the starter kit 1 pic18 (18f46j50 and debugger is 18f67j50) but I need your help to solve an issue. I was programming the PIC as usual but an error message came up. Apparently there was a need to update the firmware into the MCU but I did not see the message and disconnected the card. Now the card is no longer recognized. What I need to do to reload the original program into the MCU ? Can I do this using ICSP on J6 or J1 connections? Where can I find the original firmware?

Attached Image(s)

#1

2 Replies Related Threads
    dan1138
    Super Member
    • Total Posts : 4311
    • Reward points : 0
    • Joined: 2007/02/21 23:04:16
    • Location: 0
    • Status: offline
    Re: PIC18F STARTER KIT 1 issue 2021/01/01 12:34:06 (permalink)
    0
    You seem to need support for the DM180021 MPLAB® Starter Kit for PIC18F MCUs.

    Microchip no longer sells the DM180021 and is not available from their distributors.

    I do not have one, perhaps another member of this forum does and will help.

    Your best next step would be to use the Microchip support link and open a case.
    #2
    oliverb
    Super Member
    • Total Posts : 435
    • Reward points : 0
    • Joined: 2009/02/16 13:12:38
    • Location: 0
    • Status: offline
    Re: PIC18F STARTER KIT 1 issue 2021/03/09 02:51:17 (permalink)
    0
    It might be worth installing an older MPLAB X version, maybe as far back as 4.05 or 3.30? I'm taking a guess that support for the board might have got broken at some point?
     
    #3
    Jump to:
    © 2021 APG vNext Commercial Version 4.5