• AVR Freaks

pic32mz without ddr support .... question on resistors on vddr1v8

Author
dayhawk
New Member
  • Total Posts : 2
  • Reward points : 0
  • Joined: 2020/06/19 12:10:33
  • Location: 0
  • Status: offline
2020/06/23 23:26:21 (permalink)
0

pic32mz without ddr support .... question on resistors on vddr1v8

The manual says on pic32mz without ddr control module, to hook a resistor between vddr1v8.  What isn't clear is that there are 6 lines labeled VDDR1V8, and I am not sure if we are expected to have 6 20kohm resistors between VDDR1V8 and VSS1V8 (of which there are also 6) or if the statement was meant to tie all of the VDDR1V8 and VSS1V8 lines together, and then connect a 20kohm resistor between them.  Currently on my design (which may absolutely be wrong), I have all VSS1V8 lines attached to a gnd, and then to a 20kohm resistor.  The other side is connected to the VDDR1V8 lines all shorted together.  Would like to know though the proper way before I send this board in for fab.
#1

0 Replies Related Threads

    Jump to:
    © 2020 APG vNext Commercial Version 4.5