• AVR Freaks

AnsweredHot!Bug in System Module Configuration?

Author
phischl
New Member
  • Total Posts : 1
  • Reward points : 0
  • Joined: 2019/12/06 01:00:01
  • Location: 0
  • Status: offline
2019/12/10 08:06:12 (permalink)
0

Bug in System Module Configuration?

Hello!
 
I tried to set up the configuration for my uC with Code Configurator but seems there is a bug in the software.
I am using MPLAB X IDE v5.25, Code Configurator v3.85.1 and the PIC24FV16KM202 and try to use RA3/AN14 (Pin 10) as analog input channel.
When the "Clock Output Pin Configuration" is set to "CLKO output signal is enabled" I can choose the analog channel  "ADC1 | ANx | input" (Pin 10) in the Pin Manager/Package View. I also measured the clock signal on pin 10 with a scope. The ADC works but gives me wrong results because of the clock signal. 
When I change "Clock Output Pin Configuration" to "Port I/O enabled (CLKO disabled) it changes the pin configuration in the Pin Manager window from "ADC1 | ANx | input" to "Internal Oscillator | CLKO | output".
 
Am I doing something wrong or is there a bug in the software? I attached two screenshots to show the problem.
 
Thank you!
 

Attached Image(s)

#1
PCB
New Member
  • Total Posts : 1
  • Reward points : 0
  • Joined: 2018/07/26 20:37:31
  • Location: 0
  • Status: offline
Re: Bug in System Module Configuration? 2019/12/13 01:20:31 (permalink) ☼ Best Answerby phischl 2019/12/16 05:11:12
0
Hi phischl,
 
Thank you for reporting this issue.
Yes, the mapping between "Clock Output Pin Configuration" and Pins are incorrect.
We have fixed this and it will be a part of next release of "pic24-dspic33-pic32mm" library.
 
Regards,
PCB
#2
Jump to:
© 2020 APG vNext Commercial Version 4.5