• AVR Freaks

Snap error

Author
Post
Essentials Only Full Version
Digisoles
New Member
  • Total Posts : 5
  • Reward points : 0
  • Joined: 2018/12/30 19:17:41
  • Location: 0
  • Status: offline
2019/03/06 14:11:54 (permalink)
0

Snap error

Hi!
"I am trying to program a PIC32MX795F512L with Snap, it gives this error:
 
Script InitJTAG failed with status Type = runScript, Script name = InitJTAG, Status = 0x104
Programming did not complete."
 
Programmer speed is set to low.
 
Am using IPE Ver. 5.15 and Windows 10 64 bits.
 
Any hints?
I'd be grateful if you could help me.
post edited by Digisoles - 2019/03/06 17:41:10
#1

3 Replies Related Threads
    Digisoles
    New Member
    • Total Posts : 5
    • Reward points : 0
    • Joined: 2018/12/30 19:17:41
    • Location: 0
    • Status: offline
    Re: Snap error 2019/03/11 10:50:24 (permalink)
    0
    Hi,
    found the problem, so I'm adding the solution here for those that have the same error and search through this forum:
    You must use a USB hub, and all you nightmares will be gone. Smile: Smile
    #2
    mpgmike
    Super Member
    • Total Posts : 438
    • Reward points : 0
    • Joined: 2014/01/23 17:27:06
    • Location: NJ
    • Status: offline
    Re: Snap error 2019/03/15 07:14:44 (permalink)
    0
    I was getting that same error with Snap on a PIC16F18426 trying to load XC8 code.  I tried programming with MPLABX IPE and got different errors.  I ported the C to ASM and it loaded just fine with no Snap-related warnings.  I plugged directly into one of the PC USB ports.  The plot thickens...
    #3
    Jim Nickerson
    User 452
    • Total Posts : 6688
    • Reward points : 0
    • Joined: 2003/11/07 12:35:10
    • Location: San Diego, CA
    • Status: offline
    Re: Snap error 2019/03/15 07:25:05 (permalink)
    0
    Digisoles
    Hi,
    found the problem, so I'm adding the solution here for those that have the same error and search through this forum:
    You must use a USB hub, and all you nightmares will be gone. Smile: 


    Any USB hub ?
    USB 2 hub to PC USB 3 port ?

                               Jim.Nickerson
    specializes in designing with Microchip products. Visit theMicrochip Technology web site for more information byclicking here
    #4
    Jump to:
    © 2020 APG vNext Commercial Version 4.5