Hi, first post. Probably. Previous attempt crashed the server somehow. I am using RN4871 connected to a Teensy serial port. It works.I updated to V1.40The D command givesCMD> BTA=049162A4AE22
Services=C0 I use the F command to scan for iBeaco..
I am using RN4020 with firmware version 1.20. I want to get broadcast messages like presented on 76,
"If the RN4020 module is in the Observer role, when a broadcast message is received, it will output the message to the UART. Every new message starts a new line with the following form..
Hello.How can I download firmware 6.15 and 6.30 for the RN42 module?Thanks you very much.Best regards..
Hello,Is there a way I can get to know the 4 alphanumeric characters appended at the end of the RN4871 device name using a command? I am using multiple RN4871 and I would like to append the alphanumeric code to each file that is being generated without hardcoding it...
Hi all, I open this thread because I have some problem to exit RN4871 from dormant mode. In my application I need to put dormant mode the module (lowest consumption). I send "O,0" command (by uC) and the module turn off. If I want wake up it the document says "if S0,1; RX_IND --> LOW". What does thi..
Hello.I am using the RN42 module in a data transmission project.When I turn on the project everything works perfectly.I can establish the connection with the RN42N module and begin to transmit data through the uart.The leds ConectionStatus is fixed on and the led Activity blinks every time I send a ..
I just got my RN4871 demo board and connected it right up to my PC and issued commands perfectly. I'm trying to configure it to send and receive 'Hello Test' from my phone as an exercise. I can see the RN4871 under my Bluetooth settings and can Pair to it. I downloaded the Smart Discover App on my p..
Hi,I was going around in circles a bit trying to establish how to enable different power modes on the RN4871 and what they mean for device behaviour so I made a list of the power-mode references below. In particular, I am trying to enter the lowest power mode which draws 1 - 1.7uA according to the d..
I read a posting in this Forum sometime in the last or 4 months by someone was was successful in using a RN4871 with a Xamarin/Xamarin forms App on Android, but can't find it anymore . I have been successful in in doing this using the pre defined UIID/services - write with response and read response..
Hello guys, I ask for your help because I don't understand the procedure to wake RN4871 BLE. I put it in dormant mode by "O, 0" command, but after I don't know as active it. The document says to use "IF SO,1" command but UART doesen't work. Can anyone help me?Thanks..