Hi all,I'm using PIC24EP512GP204 with Mplab X v5.40 and MCC v4.0.1. I need to switch from core v4.85.0 to v5.0.1 in order to support 16-bit bootloader library v1.18.4 (I'm using v1.17.2 now, but it doens't support this device. The v1.18.4 supports it but requires mcc core v5.0.1).When I try to load ..
I have posted this on another site, but probably need a wider MCC user audience. I'm back on this problem from a while back, and have cobbled together the following code in an attempt to get a simple I2C transmission, but I'm struggling. I have attached a terminal and Logic analyser screen shot. My ..
Hi,a)I am using 9 channels of 16F1939 ADC in AutoConversion mode. It is working but I am getting a "hint" in MCC : "CCP5 Please configure ADC for Autoconversion". Any advice on what that means ? I have selected the compare mode as "autoconversion" in CCP5.b)In the ADC page of MCC, for some PICs, the..
I CAN'T ERASE THE THREAD BUT I THINK THIS IS A MISTAKE (because now I've seen that when I save an MCC COnfiguration it's on an *.mc3 file... so the *.mcc file that's in the project it's not "that kind of configuration" but probably a binary file that MPLabX uses originated from MCC to generate the a..
I am using the PIC24FJ128GA204 with the Curiosity dev board and MCC and need to use DMA but this doesn't seem to be an option with MCC. The device itself has DMA so it presumably should be also in MCC. Can anyone tell me if this is available with any update or if it is an error in MCC please?..
Using the MPLABX 5.45 + MCC 5.02 (library 1.169.2) with a PIC24EP256GU810 I discovered that the CAN1_MessageToBuffer(uint_fast8_t i, CAN_MSG_OBJ* message) function, generated for the CAN1 peripheral, contains a bug: the "field.frameType" has no effect and the transmitted CAN frames are always of typ..
For PIC18F67K40 mcu I have written the i2c slave code and when I get a command from I2C master the slave device receive it and send the ACK siganl for the first time only, the sencond time when I send command from I2C master the I2C slave will not respond and didnt send the ack signal also, ..
I notice increasing support for the Mikro-E Clicks in MCC. Are there plans to support this particular one? Or is it possible to just create a new project with MPLAB based on the PIC18F87K22, hook up this click board to the USB, and have MPLAB recognize it? I would really like to develop with this bo..
Hello all, I have been programming with 8-bit PICs for a little over three years now. I only recently started using the MCC to set up peripherals and I have run into an issue using the I2C functions generated. I will try to provide a good summary of what I am trying to do and the problems I have run..
Hello, after some troubleshooting found the TCP/IP lite stack would only queue 2 packets in the linked list before crashing. It appears the head packet was having it's ETH_TX_QUEUED flag cleared in function ETH_SendQueued() ClearBit( pHead->flags, ETH_TX_QUEUED); // txQueued = false Causing the next..