Hey guys im trying to interface the pic32mx795 with the LCD1602 module. I'm a complete beginner at this, so i was following along to the code samples in a book. The problem I'm facing is in the LCD.c source file (attached below); the source file was written for the HD44780 (or the ks066u, not sure, ..
See the updates below
First, i'd like to thank those who have helped me and others in the past.
I'll try to make it short.... i'm no expert on USB and may not be able to answer your questions, however, I managed to get the PIC32MZ EF to enumerate without using Harmony.
Some things may possibly ..
Does anyone know if there is a limit on the SPI interface fanout for the PIC32MZ family? I.E. , how many slaves can the 4 signals attach to before there becomes a problem? I would like to connect up to six slave SPI devices to a single master of the PIC32MZ and use GPIO for ~SS/~CS. Thanks..
Has anybody been able to get the ATECC608A working with a PIC32MZ in MPLAB X 5.45 / Harmony 3? I believe it is setup correctly in the Harmony configurator, but the 'atcab_init_device' in 'atca_basic.c' always fails before it even starts to communicate with the 608A over I2C...
Hi Microchip, I have MCP3564 Evaluation Board (ADM00583), I have several questions about it.1).- The firmware provided by you, enables int1, but in the schematic the connection is int3 (RA14/ADC_IRQ). Where am I wrong?. I am working with int1.2).- When I send the 'R\r' command, through the serial po..
Hi Guys, Is there a faster way to split a 32bit external sram address to 2 16bit PORTS on the Pic32MZ?See my code below, I've done it in 4 lines of ASM code. I tried swl $t1,PORTF to eliminate SRL and that didn't work and I can't find any other MIPS32 asm instruction to store upper and lower half wo..
Hello, We have quite a few of products developed and assembled in-house with MCUs and one of them is based on ATSAM3X8E. We don't know exactly the root cause, but SAM3X assembled boards which come out from the reflow oven are damaged, or at lest doesn't work correctly, the problems which are tracked..
When trying to start a new Harmony 3 project, it fails with attached info window,,,If I copy an old harmony.prj it will start, but with that old info....I suggest that harmony should create that file at first run? //Rolf..
Good evening, I have a simple issue. I am unable to get a breakpoint in my CN ISR to fire. I have scoped the pin and I can see a pulse with good swing and clean edges, however the ISR breakpoint is never tripped. My intent with this CN setup code is to trigger on the riding edge of RH9. I have check..