The UART echo demo program won't work on my 16-Bit 28Pin Starter Demo Board (DM300027).
Microchip work is entirely new to me.
- Win XP Pro SP3 development computer. - Demo Board comes with a PIC24FJ64GA002
- ICD 2 LE with 6 pin header connector and USB to computer. NO RJ-11 connector w..
I found there were RF0-RF1, UART TX/RX, and CDC all in PIC18F57Q43 Curiosity Nano board, but I couldn't see output either in Data Visualizer or other Serial tool, has here anyone know how to set of config it?..
Hope this is the right forum, I dont' see anything about any of theeval boards for the sama5d2. If there's a better place to ask thisplease let me know. We're working ona sama5d2 progject, and are trying to get a jump starton the software using a sama5d2-ipc evaluation board. Creating a bootableSD f..
Hello everyone, For my thesis, I'm working with the 3DTouchPad(DM160225). It was working fine but recently he is crashing after 10 or 20 "3D data". It stays in a blocked state and can't reset himself. Whereas for "2D data", it working fine until we switch to 3D recognition. It is like, it is crashin..
Hi all. - DO NOT use the arduino shield connector... the J407 is inverted, the silkscreen is not correct, haven't checked the rest.I do not have any shield but man........ i was just trying to use the pins... more info:- Use MplabX 5.3 -> newer versions do not let you use the board. I think someone ..
Hello, Is the Curiosity PIC32MZ EF (original one, not the ver. 2.0 ) supported by the Harmony v3?
All the examples and tutorials in the HArmony v3 consider only ver 2.0 of the board. On the other hand the original board was good supported in the Harmony v2. The effort to migrate is big? What is dif..
Hi all,I'm a noob to PIC32/Harmony, bought a (DM320100) PIC32MX1/2/5 starter kit, and am looking for some example code.I can only find 2 CAN examples and 2 Timer examples in Harmony, but surely there are more ?Any help appreciated.I'm ok with 8bit PICs, but might need a primer on PIC32 clocking, and..
Hello, I have a question regarding the "Licensed Debugger" which is available on the Digilent Pro MX7 board (Link).I use this board with MPLAB X (v2.10) and it's easy to connect and debug per USB.Now the problem is, we have built ~100 Devices using this board over the last years and we will need to ..
Hi All,Trying to convert TCPIP application to PIC32 Ethernet Dev Board-2. The external PHY chip is a MC LAN8740 based module. I have all the code running, but without the .c & .h files I can't complete the build. If anyone could supply these files it would be truly appreciated. I have searched e..
Is there a list somewhere of the boards that are now coming with the PKOB4 (which is a pickit4 "on board")? There are two obvious advantages.the PKOB3 has always been well.. awful. (other words come to mind though), supposedly the PKOB4 will have more or less the same hardware and firmware as the PK..