Microchip Forum Guidelines By proceeding to post you agree to follow these guidelines. OUR MAIN GUIDELINE: We require all posts to be polite, constructive, and on topic. If you do this, the rest of the guidelines won't need more than a cursory review. Section I - The Golden Rules: Be respectful of a..
Hello, I am trying to get the LwIP Netconn API working with FreeRTOS on the SAM V71 using the Atmel Start Configurator. I was able to get it to work using the Raw TCP API, but I am having some trouble using the Netconn API to do a TCP echo server. Whenever I call the function netconn_new(NETCONN_TCP..
Hello everyone, I've connected two copper ports of two distinct KSZ8765 and configured each switch to have autonegotiation disabled and 100BASE Full-Duplex mode. I have good traffic (no errors in traffic); it happens often that if i unplug/plug again the cables there are a lot of rx-symbol/rx-crc er..
Hey Guys,Im on a project using a PIC32mz1024EFK +LAN8720. The original project I started with Harmony3 and the net_server_nvm_mpfs example software from Harmony 3 applications. I developed the hardware and software integrating my software into the net_server_ example. I developed my own web pages so..
Hello, I use:PIC32MX795f512lMPLAB X IDE v5.45Harmony V3I have downloaded all the latest version of the packages at this moment. So I need to make TCPIP and FreeRTOS work together for my project.I have a few tasks that need to run in different threads and meanwhile I need to be listening for TCP comm..
Hi there,I am working on a custom board using the KSZ8041NL PHY chip with an RMII interface to send and receive messages over ethernet. The chip worked well for a time, then became unable to auto-negotiate with any connected device. I was able to fix this by disabling auto-negotiation and forcing an..
Anyone have advise on the best upgrade path to go from 10/100 to 10/100/1000baseT? The existing design is based on the KSZ8863MLL 3-port managed switch. Thank you...
Hello everyone,Currently I have the following setup:MPLABX V5.45XC32 V2.40Harmony V3 with net V3.7.0PIC32MZ Embedded Connectivity with FPU (EF) Starter Kit and the LAN8740 PHY daughterboard With the PIC set with an IP Address of 192.168.204.254 and a Subnet Mask of 255.255.255.0 and a connected lapt..
Hello, I want to use MAC to MAC in RGMII @100Mbps between KSZ9897S and CPU. I can't be sure about the connection. Is the connection below correct? KSZ9897S <=> CPURXD => TXDRX_CTL => TX_CTLRX_CLK => TX_CLKTXD <= RXDTX_CTL <= RX_CTLTX_CLK <= RX_CLKAnd also Switch's CLKO_25_125 connects to Cpu's refer..
Hi,I'm working with a KSZ8895 ethernet switch chip connected to an iMX RT1062 MCU. The switch's bootstraps are configured such that it is in SMI serial interface mode. We can read register values in the restricted MIIM set via the MCU's MDIO interface, but when attempting to read in SMI mode (i.e. t..